Cable Length | 5 m |
Process Connection | 3/4" NPT |
Temperature | 105 Deg. C |
Temperature Compensation | Yes |
Working Voltage | 5V DC |
Detection concentration range | PH 0-14 |
Detection range of temperature | 0-105 Degree C |
Working Temperature | Minus 10 to plus 105 degree C |
Working Humidity | 95%RH (nominal humidity 65%RH) |
Electrode Type | Combination Single-Junction |
pH Measurement Range | 0 to 14 |
Electrode Response Time Max | 10 Sec. |
Operating Temperature Max | 110 Degree C |
Exterior Tube Material | PPS Plastic |
Maximum Pressure | 87 psi |
Connector Type | BNC |
Rear Thread Type | 3/4 inch Pipe Thread |
Length | 160 mm |
Diameter | 29.3 mm |
This PH sensor Module consists of PH sensor also called as PH probe and a Signal Conditioning Board which gives an output which is proportional to the PH Value and can be interfaced directly to any Micro-controller.
The pH sensor components are usually combined into one device called a combination pH electrode. The measuring electrode is usually glass and quite fragile. Recent developments have replaced the glass with more durable solid-state sensors. The preamplifier is a signal-conditioning device. It takes the high-impedance pH electrode signal and changes it into a low impedance signal which the analyzer or transmitter can accept. The preamplifier also strengthens and stabilizes the signal, making it less susceptible to electrical noise.
Pins of PH sensor Module
Type of PH Meter | Wall/Pipe mounting |
Usage/Application | Laboratory |
Brand | LTH |
Model | BCD17 |
Application | Industrial |
Display | Backlit LCD |
pH Range | 0-14 pH |
Power (Volt) | 24 VDC / 230 VAC |
Accuracy (Ph) | 0.1 pH |
Material | ABS |
Temperature (Degree Celsius) | 135 Deg. C |
4.0/5
Rated by 4 Users